Google
Based on 104 reviews

Window & Door Repair in Muttontown, NY

In Muttontown, we clear clogged weep holes and fix sliding doors that grab at one spot. Call while the track is still smooth, before worn rollers dig in.

Emergency services available! Follow us:

Get a Free Estimate

Tell us what's wrong and we'll recommend the right repair.

When a window crank stalls halfway, is the window done for? Usually not. A typical Muttontown home was built in the 1970s, so crank gears and hinge arms, about fifty years old, wear out first. Both can be replaced.

Doors inside the house that rub or drift

A large one-family house can have many inside doors: bedrooms, closets, baths and pairs of doors between rooms. Wood swells and shrinks with the seasons, hinges loosen, and a door may rub, swing open on its own or miss its latch.

The top hinge tells the story: loose screws there mean the door has dropped, and we pack the hinge side to bring it back square. A latch problem needs a different look. Close the door gently; does the bolt land in its opening? If the bolt misses, we move that opening over or install a new lock body. None of this needs new doors. Make a note of each door that bothers you, and we go through them together.

Which of a slider’s parts can you test yourself?

An old metal latch on a wood window
An old metal latch on a wood window
  • Peer into the weep holes and along the track for dirt. Packed sand and grit block drainage and wear the rollers.
  • Slide the door slowly and note where it grabs. A grab in one spot means a worn roller.
  • Crank a window open and notice whether both sides rise evenly or one side trails. The trailing side may have a worn arm.
If the door still binds after you clean the track, call us while the track is still smooth, because worn rollers soon cut into it.

Cranks that stall halfway

Many houses of that age have windows that open on hinges. Some crank out from the side, and awning windows swing out from the top. Over time the crank gears and hinge arms wear. The window may stop partway, or close without sealing, and cold air then finds the gap at the frame. Wood sills and trim around doors can also soften where water sits.

We replace the worn crank or hinge arm and rebuild just the soft wood. Ask Village Hall on Tafuro Way first if the change would be visible from the road. If you can find a maker’s name on the crank, it helps us match the part.

A finished window screen leaning against a wall by a door
A finished window screen leaning against a wall by a door

Rain, cracked panes and rattling screens

A pane in the basement window cracked. Can the window be saved?

Yes. Just the glass broke, so we lift the pane out, clean the groove and bed a replacement in fresh glazing.

Where does rain get in around my side door?

It depends on the spot. Moisture low on the door points to the sweep or threshold seal; moisture up the sides points to weatherstrip or trim caulk.

What is the best way to find cold air leaking at an upper sash?

Close and lock it fully, since an unlatched sash can leak air. If air still gets by, call us, and the strip and lock get checked.

What stops a screen door from rattling?

Start with the closer. It is usually loose, or the latch has backed out of line. Tighten the closer screws first, and if the rattle stays, call us and we will line up the latch.

Why does rain keep coming through beside our storm door?

The bottom seal has usually worn thin, and a fresh sweep helps. Look along the bottom edge for a gap or a torn strip.

Free Estimate

Need a Window or Door Repaired in Muttontown?

Tell us what's wrong and we'll recommend the right repair.

Request an Estimate

Get a Free Estimate