Aerial view of Port Jefferson Harbor, the village waterfront and the wooded hills in Port Jefferson, NY
Google
Based on 104 reviews

Window & Door Repair in Port Jefferson, NY

Grinding aluminum sliders and old harbor-house sash are both fixable in Port Jefferson. Wind off the harbor pushes rain at the bottom of the windows.

Emergency services available! Follow us:

Get a Free Estimate

Tell us what's wrong and we'll recommend the right repair.

Port Jefferson has harbor houses a century or more old. Along East Main Street the district is listed for Federal and Greek Revival houses, and some may still hold their first wood windows. Newer homes from the 1960s and 1970s stand here too, and the two kinds need different things.

A wood double hung window with divided panes
A wood double hung window with divided panes

Can a tired wooden sash be saved, or must it go?

Most of the time it can be repaired, so we start with repair before we talk about replacing. In houses this old, the sash and doors were often built by hand, one at a time. The Mather House on Prospect Street, a shipbuilding family’s home, dates from about 1840 to 1860. Sash like that can be mended the same way, with each part repaired or remade to its own profile.

Replacement is for one narrow case: a sealed glass unit in a newer window that has failed. Put something dark, such as a card, behind the glass. A cloudy, milky haze means the seal is gone. Just the glass pack is swapped; the frame stays.

Who in the village should I ask about a window change?

Before you cut a new opening or make one wider or taller, ask the Village Building Department on West Broadway. Repairing a sash in place is the smaller job. Sticking sash, loose panes and stiff hinges can all be fixed that way.

Measure how far rain reaches the sill

Wind off the harbor may push rain against the bottom of a window long before rot shows. Check the sill first. The morning after a storm, look under the sill for streaks of water. If one shows, the sill pan or track gets cleared and re-sloped so water drains away instead of pooling.

In homes and apartments from the 1960s and 1970s, an aluminum slider that grinds often has grit packed in its track or a kinked rail. Look closely at the track. On a swing window, only the bent hinge pin needs replacing.

FAQ

Port Jefferson slider, vinyl and diamond-pane questions

Paint built up in the track of my aluminum slider. Is that something I can free up on my own?

First, run a plastic scraper along the paint line inside. Clear out the track and apply a dry lubricant. If it will not give at all, or the frame flexes when you push, call us. In a rented apartment, tell the building manager before you book.

A vinyl window sags at one corner and rubs. Why does it rub?

Usually a balance on that side has weakened, and adjusting the latch will not cure it. A new balance does, and we keep the frame.

Is my stuck wood sash held by paint or by swelling?

Either one can do it. Paint along the stop can be cut free, while swollen wood has to be eased and sealed. Rot in the sill is a separate job that we look at first.

Can the diamond-pane sash that binds every August be fixed?

Usually. The weight of a leaded panel can pull the sash out of true. We reset it and support the frame so the glass is not stressed.

How do I get a price?

Call us or fill out the short form at the top of this page. The estimate is free.

Free Estimate

Need a Window or Door Repaired in Port Jefferson?

Tell us what's wrong and we'll recommend the right repair.

Request an Estimate

Get a Free Estimate